Eaton - Surge filter - 100A - 3PH - 80kA - Enclosed - PPF1003CEI

Features

The Eaton PPFi is designed to provide point-of-entry (Category C) & sub-circuit protection (Category B) against power surges caused by external sources such as lightning strikes & substation switching as well as providing a measure of protection from surge events generated on the secondary side of the filter

The Eaton PPFi is a 3-stage protection system utilizing primary & secondary MOV protection in conjunction with a low-Q LC filter

The unit provides filtering of the line harmonics, noise & RF transmitters with a cut-off frequency of <10Hz & a minimum attenuation of 70dB above 1MHz

Special care has been taken in the design of the filter to minimize ringing caused by light loads, surge diverter operation & inductive load back-EMF

Applications

An ideal device for all category locations

Specifications

Dimensions (H x W x D, mm): 800 x 600 x 200

Weight (kg): 50

Warranty: 5 years

Electrical:

Input voltage: 380 - 440VAC 3 Phase

Max Continuous Voltage (Mcov): 300VAC L-N

Temporary overvoltage - TOV: 320VAC, 15 mins

Test classification: Class II

Primary protection L-N: CEi: 1,200J/ph, 3,600J total. DEi: 1,800J/ph, 5400J total. EEi: 3,600J/ph, 10,8000J total

Secondary protection L-N: CEi: 600J/ph, 1,600J total. DEi: 600J/ph, 1,800J total. EEi: 600J/ph, 1,800J total

Common mode protection N-E:CEi: 2,130J. DEi: 710J. EEi: 710J

Aggregate rating: CEi: 7,530J. DEi: 7,910J.. EEi: 13,310J

Current rating continuous (standard models): 100A

Recommended maximum over current protection: 100A

Residual current: <1 mA

Short circuit withstand (1 sec): 29kA

Protection modes: Line-Neutral, Neutral-Earth

In 8/20us (Line-Neutral) Nominal Surge Life: CEi: 30kA x 20 hits/ph; DEi: 45kA x 20 hits/ph; EEI: 90kA x 20 hits/ph

In 8/20us (Neutral-Earth) Nominal Surge Life: 45kA x 20 hits

Ismax 8/20us (Line-Neutral) Max surge level: CEi: 80kA; DEi: 120kA; EEI: 240kA

Ismax 8/20us (Neutral-Earth) Max surge level: CEi: 120kA; DEi: 40kA; EEI: 40kA

Filter attenuation: 70dB nominal above 1MHz

Initial clamp voltage (Line-Neutral): 560V (350Vac RMS)

Initial clamp voltage (Line-Earth): 1240V (700Vac RMS)

Initial clamp voltage (Neutral-Earth): 680V (420Vac RMS)

Residual voltage (Vpl) Line-Neutral: <900Vac (3kA, 8/20uS) IEC61643.1

Residual voltage (Vpl) Line-Earth: <1100Vac (3kA, 8/20uS) IEC61643.1

Residual voltage (Vpl) Neutral-Earth: <1000Vac (3kA, 8/20uS) IEC61643.1

Internal protection (fusing): All surge diverter connections are fused via HRC fuses to IEC269-2-1

Terminations: Bolted lug. 8mm bolts for phase & neutral connections

8mm PE (earth) stud provided on geartray

Communications:

Alarms/indicators: Mimic panel display via LED (2 colour), OK - Green; Protection Fault - Red. Dry contact alarm relay output 250Vac/32Vdc, 10A, 4kV isolation, Alarm under-voltage cutoff 180Vac

Environmental & Standards:

Enclosure rating: IP24

Design standards: IEC61643-1, IEC610006-1,2,3,4 ANSI/IEEE C62.41 Cat B,C,D AS1768-2007 Cat B,C,D,E AS3000, AS3100, CE mark

Environment: -10 to 65C, 10 to 90%RH (non-condensing)

Minimum sell quantity:

Order Quantity Multiple: